SOLE E98 Owner's Manual page 26

GENERAL I T
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. Ifa squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
sufficiently. I cannot stress this point enough; 90% of calls to the service department for
noise issues can be traced to loose hardware or the rear rails being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.Noise
from build-up on the rails can cause a thumping sound that you would swear is coming
from inside the main body of the machine because noise travels, and is amplified in the
tubing of the frame. Clean the rails and wheels with a lint free cloth and rubbing
alcohol. Stubborn build-up can be removed with your thumbnail or a non-metallic
scraper, like the back edge of a plastic knife. After cleaning, apply a small amount of
lubricant on the rails with your fingers or a lint free cloth.You only need a thin coat of
lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the
service department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
1. Press and hold the Start, Stop and Enter key at the same time, until the display shows
"Maintenance Menu". Press the Enter key.
2. You can now scroll through the menu using the Resistance Up/Down keys. Use the Stop
key to return to previous menu selection.The menu selections are:
A. Key Test
B. Display Test
C. Functions
I. Display Mode - Turn on to have the console power down automatically after 30 minutes of inactivity
II. Pause Mode- Turned on to allow 5 minutes of pause, turn off to have console pause in definitely
III. ODO Reset - Resets the Odometer reading to zero
IV. Units- Choose from English(Imperial) or Metric display readings
V. BrakeTest- For testing the Brake function
D. Security
E. Factory Settings
F. Exit
Incline Calibration: If there is a problem with the incline, try running the calibration. Press the Incline
A key and the Start key at the same time. Hold them down for S seconds and the Incline calibration will
start and run automatically. If the problem persists contact Sole service department.
E98 ELLIPTICAL 24