SOLE E98 Owner's Manual page 15

OPERATION OFYOU
LIPTiCAL
GETTING FAMiLiAR WiTH THE CONTROL PANEL
CONSOLE
COOLING FAN
(Manual, Hill,Fat B urn,
Card[0, Strength, Interval,
Custom, Fit-Test, 2HR)
CONTROLKEYS
(MP3, C D, O R
SMARTPHONE)
(Pulse, Time, D istance, Calories)
DOT MATRIX DISPLAY
(Program Profiles)
(Program Name, RPM, W atts,
Laps, & Incline)
POWER UP
When power is connected to the elliptical the console will automatically power up. These models are connected
directly to 115VAC and there is a power switch located where the line cord plugs into the unit on the left side near
the front (See page 4 for location).
When it is first powered on, the console will perform an internal self-test. During this time all the lights will turn on,
the Message Window display will show a software version (i.e.: VER 1.0), and the Distance Window will display an
odometer reading. The odometer shows how many virtual miles the elliptical has gone. The Time Window shows
how many total hours the elliptical has been used.
The odometer and time will remain displayed for only a few seconds then the console will go to the startup display.
The dot matrix display will be scrolling through the different workout profiles and the Message Window will be
scrolling the start up message. You may now begin to use the console.
!!ATTENTION
Your new elliptical console comes configured in an in-store 'display mode' of operation, where the console will
remain powered on unless the main power switch is turned off. To exit the display mode, for normal operation,
press and hold the Stop, Enter and Display keys for five seconds; the display will show: Display Mode- ON.
Use the Level A/-- key to change the setting to OFF then press Enter.
13 E98 ELLIPTICAL