Pentax OPTIO WS80 Operating Manual page 55

Press the shutter release button fully.
After the message [Start interval shooting] appears, the display turns
off. When [Start Delay] is set to [0 min.], the display turns off after the
image immediately taken appears in Instant Review.
When the time set in [Total Time] elapses, the message [Interval
shooting complete] appears and the camera turns off.
• Confirm that the battery is sufficiently charged before starting
recording. If the battery is not sufficiently charged, it may become
depleted during recording and cause recording of the movie to stop.
• The alarm will not ring during interval shooting.
• The display turns off between shots (during standby). Press the power
switch during standby to display the remaining recordable time and
interval on the display.
• The message [Stop interval shooting?] appears when the power
switch and then the MENU button are pressed during standby, To
cancel interval shooting, press the OK button
• In Interval Movie mode. the number of recorded pixels for still pictures
is fixed at 1640(640x480) and the flash mode is fixed at @ (Flash Off).
• MF cannot be selected for the focus mode.
• The time remaining until recording starts is displayed on the monitor
u p until recording begins.
• [Total Time] varies depending on the [Interval] setting and movie frame
rate (p.128). The total time that can be set are as follows.
10 minutes to 5 hours 10 minutes to 5 hours and
1 rain.
and 59 minutes 59 minutes
30 minutes to 29 hours 15 minutes to 29 hours and
5 rain.
and 55 minutes 55 minutes
1 hour to 59 hours and 30 minutes to 59 hours and
10 rain.
50 minutes 50 minutes
3 hours to 179 hours 1 hour and 30 minutes to
30 rain.
and 30 minutes 179 hours and 30 minutes
1 hr. 6 hours to 359 hours 3 hours to 359 hours
when the frame rate setting is 30 fPS130 frames of still pictures are played back
each second; as a moyie. When the frame rate setting is !5 fPS, t5 frames are
p!ayed back each second,
• Settings for interval movie can also be made in [Movie] in th e [a Rec,
Mode]menu:Perform Steps 6 to 11 to make the settings.