Pentax OPTIO WS80 Operating Manual page 19

i_i!!
iiiiiiiiiiiiiiii_iii:ii ¸
ii'i_!iiiiiiiiiiiiiiiiiiiiiiiii!_!!_iii_!ii_iii_i_ii
iiiiiiiiiiii'ii_i_ii@:_i:_ii:ii:iil
iiiiiiii_i'!_:ii:ii:ii:ii:ii:ii_ii!_i_i
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii i' i'=!i !i !ii ii:i
iiiilililililililililililililililililililililililililililililil
5 Press the shutter release button fully.
The picture is taken ten seconds or two seconds later.
Focusing may be compromised if you move the camera While the self.
timer lamp is blinking when taking still pictures.
' !n ,!I_(Movie) and _ (Underwater Movie)modes, recording will start
after ten seconds (or two sec0nds).
• Press the shutter release button halfway while the self-timer is engaged
1o stop the countdown and press ful!y t0 restart the c0untd0wn
• @ cannot be selected while I (Green) mode setting remains the
default. Select @in an0ther sh0oting m0de and then switch the
shooting mode to a.
In these modes, pictures are taken continuously as long as the shutter
release button is pressed.
Each time a picture is taken, the image is saved in the memory
Continuous before the next image is taken. The higher the image quality, the
longer the interval between shots.
Shooting You can continue shooting until the memory of the SD Memory
Card or the built-in memory is full.
Burst The number of recorded pixels is fixed at _ (2592x1944) and
up to 7 pictures are taken consecutively at 3.3 frames per second
DdlHs Shooting (5.6 frames per second when the sensitivity is 3200 or 6400).
Shutter release
button
1 Press the four-way controller (&)in a mode.
The [Drive Mode] screen appears.