Pentax K-5 Operating Manual page 136

6
7
8
9
When a spot area is selected, use the four-way controller
(A • • • ) to move the frame to the position you want to
measure.
Press the
OK
button.
The white balance fine-tuning screen
appears when measuring is completed.
Adjust the white balance as necessary.
(p.207)
Manual _C_1
White Balance
_Adjust
=+0 4±0_
Press the
OK
button.
The camera returns to the [White Balance] screen.
Press the OK button.
The camera is ready to take a picture.
• No mage is recorded when the shutter release button is pressed to adjust
the white balance.
• The message [The operation could not be completed correctly] appears
when measuring is unsuccessful Press the OK button while displayed to
remeasure the white balance.
• If a picture is extremely overexposed or underexposed, the white balance
may not be adjusted. In this case. adjust exposu re to the correct amount level
before adjusting the white balance.
• When the mode dial is set to J_ (Movie), the white balance cannot be
measured. Adjust the white balance in any exposure mode other than _I_
before recording a movie.