Video Cassette Playback - Philips DVD740VR Owner's Manual

76 Video Cassette Playback
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • =w
VCR
Read and follow the steps below to play a tape.
1
Turn on the TV and set it to channel 3 or 4,
whichever channel the CH3/CH4 switch on the back of the
DVD/VCR is set to. Or, if you connected the DVD/VCR to
the TV using audio and video cables, select the correct
audio and video in channel at the TV. Details are on page 77.
2
With the DVD/VCR power off, insert a tape in the
cassette compartment of the DVD/VCR. The Power,
VIDEO, VCR/TV, and CST. IN lights will appear on the
front of the DVD/VCR. If the tape's record tab has been
removed, playback will start automatically.
If the DVD/VCR power is already on, press OUTPUT
SELECT to put the DVD/VCR in VCR mode if necessary.
The green VIDEO light will appear on the front of the
DVD/VCR.
3
4
If playback does not start automatically, press VCR,
then press PLAY II_ (A).
Press STOP • (v) to stop playback.
Turn on the TV.
Insert a tape in the
DVDIVCR.
O
REPEAT nEPEA_
O ®
4-
©©®
®®®
o3
Press REW _ (_1) to rewind the tape.
After the tape stops, press STOP/EJECT on the DVD/VCR to remove the tape.
Press STOP/EJECT on the
DVD/VCR.
If the tape you want to play is
already in the DVD/VCR,make sure
the DVD/VCR power is on and the
DVD/VCR is in VCRmode and VCR
position. (The green VIDEO light and
the VCR/TVlight will appear on the
front of the DVD/VCR.)Press VCR,
then press PLAYI_ (A).
Other tape playback options and
features are on pages 39-46.
When you play a tape recorded in
S-VHS format on this unit, you can
not get the high resolution that
would be available on an S-VNS
VCR. Noise lines (black and white
streaks) may appear on the picture.
If REPEATPLAYis ON, playback will
begin automatically when you insert
a tape, even when the record tab is
intact. Details are on page 39.
You must connect the DVD/VCR to
a TV using the RE coaxial cable or
the audio/video cables in order to
use the VCR features.