Magic Chef CGS1740ADL Owner's Manual page 8

Under n ocircumstances arethesurface burner
assemblies to betakenapart f orcleaning. Thesurface
burner a ssembly canberemoved t oclean the burner box
area.
Freestanding Range Only:
The two surface burner assemblies are secured in place
during transportation with screws. Once the range is
installed, these screws may be removed to allow quick
and easy removal of the burner assemblies.
The porcelain on the burner is durable but may gradually
lose its shine due to usage and high temperatures.
The sealed surface burners are secured to the cooktop
and are NOT designed to be removed by the consumer.
Select models feature two special SUPER HIGH SPEED
sealed burners located at the right-front and left-rear. Use
these burners to quickly bring water to a boil and when
using larger pans. See information on rating plate, located
on the lower range front frame, to determine if your
appliance features these burners.
To remove: Allow the burner assembly to cool. Lift up
cooktop. Grasp the burner assembly and rotate it slightly
toward the left to release the two tabs on the assembly.
Then lift the assembly and pull toward the back of the
cooktop until the air shutter ends on the assembly release
from the valves.
To replace: Insert the air shutter ends on the burner
assembly over the valves and lower the assembly into
place. Be sure to secure the two tabs on the burner
assembly into the two slots on the burner support bracket
which is mounted to the burner box bottom. (NOTE: If the
tabs are not properly inserted into the slots, the assembly
may rock and the burners may not light properly.)
Lip
Ports
Ignitor
ly below ignitor
Clean burner cap after each use especially if a spillover
occurs. A soiled burner may result in improper ignition or
an uneven flame. When cleaning the sealed surface
burner, use care to prevent damage to the ignitor. If a
cleaning cloth should catch the ignitor, it could be
damaged or broken.
The surface burner will not light if the ignitor is damaged,
broken, soiled or wet. The burner will also not light if the
ports, especially the small port located directly below the
ignitor, are blocked. See page 17 for cleaning instructions.
NOTE: When one surface burner is turned to the LITE
position, all four ignitors will spark. Once the burner lights,
turn the knob to the desired flame size.