Magic Chef CGS1740ADL Owner's Manual page 21

STORAGE DRAWER':
The storage drawer at the bottom of the range is safe and
convenient for storing metal and glass cookware. DO
NOT store plastic, paperware, food or flammable material
in this drawer. Remove drawer to clean under range.
PROPORTIONAL VALVE ADJUSTMENT
The LO setting should produce a stable flame when
turning the knob from HI to LO. On conventional surface
burners, the flame should be 1/8 inch or lower and must
be stable on all ports on LO setting. For sealed burners,
the flame should extend to the outer edge of the lip on the
burner cap on the LO setting.
To adjust: Operate burner on HI for about 5 minutes to
preheat burner cap. Turn knob back to LO; remove knob,
and insert a small screwdriver into the center of the valve
stem. Adjust flame size by turning adjustment screw in
either direction.
To remove: Pull drawer out to the first stop position. Lift
up front of drawer and pull to the second stop position.
Grasp sides and lift up and out.
To replace: Fit the rollers located at the ends of the
drawer glides into the rails on the range. Lift up drawer
front and gently push in to first stop position. Lift up
drawer again and continue to slide drawer to the closed
position.
Some floors are not level.
For proper baking, your
range must be level.
Leveling legs are located
on each corner at the base
of the range. Level by
turning the legs. To prevent
range from accidently
tipping, range should be secured to the floor by sliding a
rear leveling leg into the anti-tip bracket supplied with the
range.
Flame must be of sufficient size to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY on the
LO setting. Never adjust flame size on a higher setting.
NOTE: All gas adjustments should be done by a qualified
servicer only.
Appliances which require electrical power are
equipped with a three-prong grounding plug which
must be plugged directly into a properly grounded
three-hole 120 volt electrical outlet.
Always disconnect power to appliance before servicing,
The three-prong grounding plug offers protection against
shock hazards. Do not cut or remove the third
grounding prong from the power cord plug.
If an ungrounded, two-hole or other type electrical outlet
encountered, it is the personal responsibility of the
appliance owner to have the outlet replaced with a
properly grounded three-hole electrical outlet.
i
i
I
!
I