Sears LXI series 580.55914490 Owner's Manual page 27

Example 1-2: This SET-UP uses the optional "A-B switch" to select viewing of
broadcast TV or CAMCORDER tapes.
UHF Antenna
' '/_ ? _/I '--'
I I _ i This is an adaptor
of 751300-ohm
| cambination type
| and may be used as
l___ _ applicable"
75-ohm coaxial
cable with antenna
adaptor.
VHF Antenna
Camcorder
N I[_I. NI
J.riO
i I
j_
Antenna Adaptor
(300-ohm to 75-ohm)
Antenna Selector Unit
RF Converter Unit
.@"
o •
AUDIO OUT and
VIDEO OUT Jacks
1. Disconnect the VHF antenna leads from the rear
of the TV receiver.
NOTE: Leave the UHF antenna leads connected
to the TV.
2. Connect the VHF antenna lead to "IN2" on the
antenna selector unit. If the cable is round (75-
ohm), it will connect directly to the "IN2". If it is
the flat type (300-ohm), connect it to a 300-ohm
to 75-ohm antenna adaptor (not supplied) as
shown above and slip the adaptor on to the "IN2"
terminal.
3. Connect the 75-ohm coaxial cable with antenna
adaptor to "OUT" on the antenna selector unit.
Connect the other end to the VHF antenna
terminal on the TV, as illustrated.
4. Connect the RF Converter Unit Selector Unit to
"AUDIONIDEO OUT" jack on the Camcorder.
5. To play Camcorder through your TV, set the
selector unit to IN1 and follow the instruction
steps 4~8 on page 25.
6. To watch TV, set the selector unit to IN2.
26