Setting The Time And Date - Sears LXI series 580.55914490 Owner's Manual

SETTING THE TIME AND DATE
The time and date can be recorded on your tapes to act as a handy reference when viewing them at a later
time. Use the following procedure to set up this display for the current time and date. The date/time graphics will
be recorded whenever they appear in the viewfinder. To display time and date together, press "DATE/TIME". To
display date only, press "DATE/TIME" again. Pressing "DATE/TIME" a third time removes both graphics.
1. Load the video camcorder's date/time battery as
described on page 7.
2. Turn on Power of the video camcorder. Set to
"CAM".
3. Press and hold "DATE/
TIME" button.
"12:00 AM" and "01.01.94"
appears in the viewfinder
and flashes.
4. Hold button down until "12"
flashes.
I xii 1
-12:08-AM
,011/0"I/94
5. Press "ENTER" button to select correct hour.
Hold button down to advance rapidly. When the
correct hour appears, press "SHIFT" button.
I \1/ t
06:00 AM
o'f/0"f/94
6. Press "ENTER" button to select correct minute.
Hold button down to advance rapidly. When the
correct minute appears, press "SHIFT" button.
06:39-AM
01/01/_4 \9
7. Press "ENTER" button to select AM or PM, and
then press "SHIFT" button..
I \06:.30 PM 1
-- 09108/94
/i \
8. Press "ENTER" button as many times as may be
required to select month, and then press "SHIFT"
button.
9. Repeat step 8 to select date and year.
I 06:30 PM 1
09108/94
10. Press"DATE/TIME" button to activate the
date/time.
11. Press "DATE/TIME" button to remove the
date/time display from the viewfinder. The
date/time will continue to keep the correct
time/date in memory.
NOTE: To correct date/time information during
programming, press "SHIFT" button until the
incorrect digit is flashing. Then use "ENTER" button
to enter the correct digit. If you wish to correct
information after starting the date/time, first press
and hold "DATE/TIME" button, then press "SHIFT"
and repeat steps 5 through 11.
9