GE JAP02 Owner's Manual And Installation Instructions page 38

Before You Call For Service...
Troubleshooting Tips
Problem Possible Causes What To Do
Oven - All Models
Oven light does not Light bulb is loose or defective. . Tighten or replace the bulb.
work Switch operating light is . Call for service.
broken.
Oven will not work Plug on range is not completely . Make sure electrical plug is plugged into a live properly
inserted in the electrical outlet, grounded outlet.
A fuse in your home may be . Replacethe fuse or reset the circuit breaker.
blown, or the circuit breaker
tripped.
Oven controls improperly set. . See the Using the oven section.
On self-cleaning models, door left . If necessary, allow the oven to cool then unlock the door.
in the locked position.
Food does not bake or Oven controls improperly set. . See the Using the oven section.
roast properly Rock position is incorrect or the . See the Using the oven section.
rack is not level.
Incorrect cookware or . See the Using the oven section.
cookware of improper size
being used.
Oven thermostat needs . See the Adjust the oven thermostat-Easy to do yourselfi
adjustment, section.
Food does not broil Oven is not set to BROIL. . On models with a temperature knob, make sure you turn
properly it all the way to the BROIL position. On models with a
BROIL pad, make sure it is turned on.
Improper rack position being . See the Broiling Guide.
used
Food being cooked in a hot pan. . Use the broiling pan and grid that came with your range.
Hake sure it is cool.
Cookware not suited for . Use the broiling pan and grid that came with your range.
broiling.
Aluminum foil used on the . See the Using the oven section.
broiling pun end grid has not
been fitted properly and slit as
recommended.
In some areas, the power . Preheat the broil element for 10 minutes.
(voltage) may be low.
. Broil for the longest period of time recommended in the
Broiling Guide.
Control signals after You forgot to enter a boRe Press the BAKE pad and desired temperature or the CLEAN
entering cooking time temperature or cleaning time. pad and desired clean time.
or Self-Clean
DJsplayflashes "bAd" The installed connection Contact installer or electrician to correct miswire
then "linE" with a loud from the house to the unit is
tone. miswired.
38