GE JAP02 Owner's Manual And Installation Instructions page 35

Installation Instructions
INSTALL THE RANGE
ANTI-TIP DEVICE INSTALLATION
Tip-Over Hazard
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back so the anti-tip arm slidesunder the anti-tip
bracket.
• Re-engage the anti-tipbracket if the range ismoved,
• Failureto do so can resultin death or serious burns
to childrenor adults,
To reduce the risk of tipping the range, the range
must be secured by a properly installed anti-tip
bracket. See installation instructions shipped with the
bracket for complete details before attempting to
install.
To check if the bracket is installed and engaged
properly, look underneath the range to see that the
anti-tip arm attached to the side panel is engaged
in the bracket. On some models, the storage drawer
or kick panel can be removed for easier inspection.
If visual inspection is not possible, slide the range
forward, confirm the anti-tip bracket is securely
attached to the floor or wall, and slide the range
back so the anti-tip arm slidesjust under the anti-tip
bracket. If the range is pulled from the wall for any
reason, always repeat this procedure to verify the
range is properly secured by the anti-tip bracket.
rio] REMOVE STORAGE DRAWER
r_ Pullthe drawer out oll the way.
r_ Lift the front of the drawer until the stops clear the guide.
r_ Removethe drawer.
@
@
LEVEL THE RANGE
Install the oven racks in the oven and position the
range where it is to be installed.
Check for levelness by
placing a spirit level or a
cup, partially filled with
water, on one of the oven
racks. If using a spirit level,
take two readings - with the
level placed diagonally first
in one direction and then
the other.
The front leveling legs can be adjusted from the
bottom and the rear legs can be adjusted from
the top or the bottom.
Use an open-end or adjustable wrench to adjust
the leveling legs until the range is level.
35