GE Profile 42 Owner's Manual And Installation Instructions page 35

Installation Instructions
[] CONNECT POWER
• Connect refrigerator power cord plug to
a properlu grounded receptacle. Set the
Master Power switch to the I (ON) position.
x _
/" \
Master Water Filter
Power Switch
i
• Check to make sure power to refrigerator
is on by opening refrigerator door to see
if interior lights are on.
CAUTION:
• After power has been established, turn the
Master Power switch to the O (OFF) position.
[]
MOVE INTO INSTALLATION SPACE
• Slide the unit into the installation space.
• Place excess slack in the power cord on top
of the refrigerator.
• Use care to ensure the power cord is not pinched
behind the unit.
f_
i Height
,,= i from
k i Floorto
i Bollorn
i of Wood
Block
82"
[] LEVEL REFRIGERATOR
All models have 4-point leveling. The front and back
are supported bu leveling legs. Both are accessible
from the front of the refrigerator.
• To level the back of the refrigerator, turn the 1/2"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower
the refrigeraton
• For front leveling, use a 7/16" open-end wrench.
• Adjust height of refrigerator to match
installation cutout opening 83-1/2" to 84-:1/2".
The refrigerator should be level and plumb with
cabinets.
I
LevelingLeg _,__
_J He'H'H_x NutAdjusts
y l_Rear LevelingLegs
IMPORTANT NOTE: The refrigerator must be level.
If it is not, the doors ma U not align evenl U at
the top. See Step 16.
CAUTION:
The rear leveling legs and front leveling legs
are limited to a maximum height adjustment
of 1". If the installation requires more than 84-1/2"
height, the installer should elevate the refrigerator
on a sheet of pluwood or runners. Cabinet trim
could be added across the top of the opening
to shorten the opening. If you attempt to raise
the refrigerator more than Y', gou will damage
the front and rear leveling legs.
35