GE Profile 42 Owner's Manual And Installation Instructions page 26

Installation Instructions
3/4" FULL-WIDTH OVERLAY CUSTOM PANELS WITH PRE-INSTALLED HANDLES
This panel design provides a nearlu trimless appearance.
Assemble the spacer panel onto the backer panel. Allow 1/2" clearance on all four sides of the grille spacer
panel. Allow 1/2" clearance on the top and hinge side, 15/16" on the bottom and 3%/8" on the handle side of
the upper freezer door panel. Allow 15/16" on the top, 1/2" clearance on the bottom and hinge side and 3-5/8"
on the handle side of the lower freezer door panel. Secure the panels with glue. Be sure to observe clearances
on all sides.
Secure the appearance panel to the assembled backer/spacer panel. Use glue
and screws. Countersink screws into the backer panel.
Grille Panel
[-'_,_ll_[oit['l
1i4"BackerPanel 39-15116" 10-314"
O.lO"Spacer Panel 38-15/16" 9-3/4"
3/4"OverlagPanel 40-3116" 11"
[,!F_ll_ lil, [-t
1/4"Backer Panel 45-15116" 10-3/4"
0.10"Spacer Panel 44-15116" 9-3/4"
3/4"OverlagPanel 46-3/16" 11"
Upper Freezer Panel
[-_,/_1 _ [o]t 1"1
114"Backer Panel 16-7/16" 17-13/16"
0.10"Spacer Panel 12-5/16" 16-3/8"
3/4"OverlagPanel 13-7/16" 17-5/8"
E,!Bil& lil, [_.
1/4"Backer Panel 18-7116" 17-13116"
0.10"Spacer Panel 14-B116" 16-318"
3/4"OveHag Panel 15-7/16" 17-5/8"
Lower Freezer Panel
[_*tl _ 1.]* ['t
1/4"Backer Panel 16-7116" 35-1/8"
0.10"Spacer Panel 12-5/16" 33-11/16"
3/4"OverlagPanel 13-7/16" 34-15/16"
[,_;tl _ 1.]* ['t
1/4"BackerPanel 18-7116" 35-1/8"
0.10"Spacer Panel 14-5116" 33-11/16"
3/4"OverlagPanel 15-7/16" 34-15/16"
5/16"
Upper Freezer Panel
Spacer Assemblg
3-1/8"
A
3-1/8"
Requiredfor Optimal
Handle Clearance
Lower Freezer Panel
Spacer Assemblg
3-5/8"
1/2"
Finished
BackerPanel
1/2"
Finished
BackerPanel
26