GE Profile PV977 Owner's Manual And Installation Instructions page 4

Using the hood controls.
0
0
@
O0 ©0 0
PTOj_/e - FAN + -- LIGHT + MEMORY/
OFF
@ 0 0
MEMORY/OFR To set the memorg:
A. Press the MEMORY/OFF button.
B. Set gout desired fan and light settings.
C. Press the MEMORY/OFF button again to save
these settings.
With gout desired settings in memorg, press the
MEMORY/OFF button to restore the fan and light
levels to their saved settings. These settings will
remain in memorg until theg are changed or loss
of power occurs.
To turn offthe hood, press the MEMORY/OFF
button.
LIGHT. Press + or - to increase or decrease light
level to desired setting. There are 2 light levels
(LOW, HIGH) and OFF. If you continue to press
the + or - buttons, the light will cgcle back through
the settings.
NOTE:Please check the lamps to ensure onlg 20W
lamps (maximum) are installed.
FAN. Press + or - to increase or decrease fan
level to gour desired setting. There are 4 fan levels
(LOW, MED, HIGH, BOOST)and OFF. If gou continue
to press the + or - buttons, the fan will cgcle back
through the settings.
NOTE:There is an audible "beep" each time
a button is pressed. This is normal.
NOTE:The collars around the buttons will illuminate
when pressed. This is normal. The collars will
automaticallg turn off if the hood is turned off.
HEAT SENSOR:
This hood is equipped with a heat sensor that will turn
on the fan if excessive temperatures are detected
(over 70°C/158°F) above the cooking surface. The hood
will return to its normal operation once the heat sensor
detects temperatures below 60°C/140°F.
NOTE: If the hood is OFF or on LOW fan speed,
the temperatures above 70°C/158°F are detected;
then the fan will automatically adjust to MED speed.
You may adjust the fan speed to HIGH or BOOST,
but you will not be able to adjust the fan speed to LOW
or OFF until temperatures below 60°C/140°F are detected.
NOTE:The collars around the buttons mag not illuminate
if the heat sensor is activated. This is normal.
4