Start-Up Sequence Sit Prolame Gas Valve; Lighting Instructions; To Turn Off Gas To Appliance - Montigo H34DL Installation & Maintenance Manual

For Your Safety - READ BEFORE LIGHTING:
A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to light
the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
„
Do not touch any electrical switch; do not use any phone in
„
your building.
Immediately call your gas supplier from a neighbour's phone.
„
Follow the gas supplier's instructions.
1. STOP! Read the safety information above on this label.
2. Remove the lower Horizontal access panel.
3. Turn Incoming gas valve to the ON" position.
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Turn wall switch "ON".
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
1. Turn off remote switch.
2. Remove the lower Horizontal access panel.
XG0140 - 120611.1
Operation
IPI Electronic Ignition
with American Flame Electronic Ignition
NOTICE
You must read and understand this manual prior to installation, operation or
troubleshooting this appliance. Please retain this owner's manual for furure reference
and maintenance.

Lighting Instructions:

Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)

To Turn Off Gas To Appliance:

(SIT Proflame)
If you cannot reach your gas supplier, call the Fire Department.
„
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
6. If the Fireplace does not light, the System will cycle through
two trials, (one minute audible clicking, thirty seconds of
silence, and then another one minute of audible clicking).
7. After completion of the information in the Troubleshooting
section, Repeat step 5.
8. If the system will not function correctly, follow the instruc-
tions "To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
EV1 (Pilot
burner)
Gas "In"
Incoming Gas
Line, Shut-off
Valve
3. Turn the incoming gas control valve to "Off".
4. Replace the lower Horizontal access panel.
H-Series DL Indoor Gas Fireplace
EV2 (Main
burner)
Pilot Adjust Screw
Gas "Out"
To fireplace Main
burner
Page 27