Start-Up Sequence Sit Proflame Gas Valve; Lighting Instructions; To Turn Off Gas To Appliance - Montigo H38DF ST Installation & Maintenance Manual

H*38DF ST Indoor Gas Fireplace
For Your Safety - READ BEFORE LIGHTING:
You must read and understand this manual prior to installation, operation or
troubleshooting this appliance. Please retain this owner's manual for furure reference
and maintenance.
A. This appliance is equipped with an ignition system that lights
the pilot burner automatically. Do not attempt to light the pilot
by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
„
Do not touch any electrical switch; do not use any phone
„
in your building.
Immediately call your gas supplier from a neighbour's
„
1. STOP! Read the safety information above on this label.
2. Remove the lower Horizontal access panel.
3. Turn Incoming gas valve to the ON" position.
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP! Follow "B" in the safety information above on this
label. If you don't smell gas, go to the next step.
5. Turn wall switch "ON".
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
1. Turn off remote switch.
2. Remove the lower Horizontal access panel.
Page 24
Operation
SIT Proflame Electronic Ignition
with American Flame Electronic Ignition
NOTICE

Lighting Instructions:

Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)

To Turn Off Gas To Appliance:

Models Included
H38FSDNI
HL38FSDNI
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire
„
Department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician.
Force or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system,
and any gas control which has been under water.
6. If the Fireplace does not light, the System will cycle through
two trials, (one minute audible clicking, thirty seconds of
silence, and then another one minute of audible clicking).
7. After completion of the information in the Troubleshooting
section, Repeat step 5.
8. If the system will not function correctly, follow the instruc-
tions "To Turn Off Gas To Appliance" and call your service
technician or gas supplier.
EV1 (Pilot
burner)
Gas "In"
Incoming Gas
Line, Shut-off
Valve
3. Turn the incoming gas control valve to "Off".
4. Replace the lower Horizontal access panel.
H38FSDLI
HL38FSDLI
EV2 (Main
burner)
Pilot Adjust Screw
Gas "Out"
To fireplace Main
burner
XG0207 - 011012.1