Hardware Settings Page - M-Audio Delta 1010 Manual

5 & 6, or 7 & 8 (respectively) directly to the 1010's hardware analog outputs 3
& 4. For example, if "H/W In 1/2" were selected, any signal present at the IN1
port will be copied to OUT3, and any signal present at the IN2 port will be
copied to OUT4. This same behavior applies to "H/W In 3/4", "H/W In 5/6",
and "H/W In 7/8" when selected.
The rightmost vertical column of Patchbay/Router page, "H/W Out S/PDIF,"
connects the Delta 1010's hardware S/PDIF outputs to one of eight sources:
1. The default setting, "WavOut S/PDIF", connects the S/PDIF Out port to your
music software or Windows multimedia applet. In other words, when music
software plays audio to the device named "WavOut S/PDIF Delta-1010" it will
be routed directly to the hardware S/PDIF output on your Delta 1010 PCI host
card.
2. The second option, "Monitor Mixer", connects the S/PDIF Out port to the
outputs of the Delta 1010 monitor mixer. For more information on the
capabilities of the monitor mixer, please see the section "Monitor Mixer Page".
3. The third option, "S/PDIF In", connects the S/PDIF Out port directly to the
hardware S/PDIF input on the Delta 1010 PCI host card. The left channel of
the S/PDIF In is routed to the left channel of S/PDIF Out and the right
channel of the S/PDIF In is routed to the right channel of S/PDIF Out.
4. The fourth option, "S/PDIF In (L/R Rev.)", functions identically to the third
option, except that the left and right channels are swapped. Therefore in this
mode, the left channel of the S/PDIF In is routed to the right channel of
S/PDIF Out and the right channel of the S/PDIF In is routed to the left
channel of S/PDIF Out.
5. Selections five through eight connect the hardware analog inputs 1 & 2, 3 & 4,
5 & 6, or 7 & 8 (respectively) directly to the 1010's S/PDIF Out port. For
example, if "H/W In 1/2" were selected, any signal present at the IN1 port
will be sent to the left channel of the S/PDIF Out, and any signal present at
the IN2 port will be sent to the right channel of the S/PDIF Out. This same
behavior applies to "H/W In 3/4", "H/W In 5/6", and "H/W In 7/8" when
selected.
At this point, you may begin to realize the versatility of the Monitor Mixer and
the Patchbay/Router, and the relationship between the two. You may want to re-
read this section and make some practice adjustments within the Delta Control
Panel software to become proficient in routing and mixing. If somewhere in the
process you become confused, you may always restore the default settings to use
the card as a straight 10-in 10-out device -- just choose the topmost option in
each of the Patchbay/Router columns.

Hardware Settings Page

The Hardware Settings page of the Delta Control Panel gives you control over
miscellaneous features of the Delta 1010.
"Hardware Settings" tab of the Delta Control Panel.
To display this page, click the
22