About Page; Save, Delete, Load Buttons; H/W Installed - M-Audio Delta 1010 Manual

CONSUMER FORMAT ADVANCED SETTINGS (Emphasis): This status
bit is used to indicate if pre-emphasis has been applied to the outgoing digital
audio signal. The default is "None" and rarely will any user want to set the value
to "50/15uSec" unless the transmitted audio has been encoded with 50/15uSec
pre-emphasis.
PROFESSIONAL FORMAT ADVANCED SETTINGS (Data Type): The
user may assign the outgoing data as audio or non-audio data. Many devices
ignore this setting. The obvious default is "audio."
PROFESSIONAL FORMAT ADVANCED SETTINGS (Emphasis): The
user may choose to indicate or not indicate if pre-emphasis has been applied to
the outgoing digital audio signal. The default is "None" and rarely will any user
want to set the value to "CCITT" or "50/15uSec" unless the transmitted audio has
been encoded with one of those types of pre-emphasis.

About Page

The "About" page, while displaying the handsome M Audio logo and applicable
copyright information, also reports the driver version and control panel software
version. If you have Internet browsing capabilities and are currently connected
to the Internet, clicking on the Midiman copyright will link you to the M Audio
/ Midiman web site (PC only).

Save, Delete, Load Buttons; H/W Installed

On the PC, at the rightmost side of the Delta Control Panel are the Save, Load
and Delete buttons as well as an "installed hardware" set of radio buttons. These
controls appear regardless of what Delta Control Panel page is being displayed.
To save your settin
SAVE, DELETE, LOAD: The Delta Control Panel always retains the last
settings entered. However the Save, Delete, and Load functions expand this
capability to store different sets of control panel settings using different
configuration file names. These configurations are then available for recall at a
later date and time.
Clicking the 'Save' button brings up a dialog box prompting you to name the current
configuration. Once you have done this, click 'OK', and your current configuration
has been saved to disk. If you decide that you no longer need a particular
configuration, click the 'Delete' button. Highlight the name of the configuration file
that you wish to delete, and click the 'OK' button. To recall or reload a saved
configuration, click the 'Load' button. Highlight the name of the configuration file
that you wish to recall, and click 'OK'. Those settings will now appear in the Delta
Control Panel and the driver will automatically update the hardware.
27