Transferring From Dat To Delta 1010 - M-Audio Delta 1010 Manual

Delta 1010
Delta 1010 and the Delta 1010 and the
M Audio product line is
M Audio product line are
produced by MIDIMAN. produced by MIDIMAN.
Delta 1010 PCI
Card in Computer

Transferring from DAT to Delta 1010

1. Connect the DAT's coaxial S/PDIF output to the S/PDIF In of the Delta 1010
PCI host card, using a good quality cable.
2. Connect the 1010 analog outputs 1 & 2 to some type of amplified sound
system. The sound system should be equipped with speakers or head-
phones. Set the +4/-10 switches on OUT1 and OUT2 to be compatible with
that sound system's inputs.
3. Because you will be recording from the S/PDIF input, you will need to set up
the Delta 1010 to synchronize its master clock with the S/PDIF input. To do
this, open the Hardware Settings page of the control panel software. Under
Master Clock, select "S/PDIF In."
4. Next, you will need to tell your application software the expected sample rate.
We'll use 44.1 kHz in this example. Therefore, on the Hardware Settings page,
set the "S/PDIF Sample Rate" to 44,100.
5. In order to monitor the digital signal coming into the 1010, switch to the
Patchbay/Router page of the control panel software. In the "H/W Out 1/2"
Wordclock
Wordclock
Ins
In In Out Out
8
+4 -10 8
Host Cable
Host Cable
Outs
DAT
7 6 5 4 3 2
7 6 5 4 3 2
39
9 VAC
1
1
Sound System