M-Audio Delta 1010 Manual page 16

Analog In1 Delta-1010
Analog In2 Delta-1010
Analog In3 Delta-1010
Analog In4 Delta-1010
Analog In5 Delta-1010
Analog In6 Delta-1010
Analog In7 Delta-1010
Analog In8 Delta-1010
S/PDIF In L Delta-1010
S/PDIF In R Delta-1010
Mon. Mixer L Delta-1010
Mon. Mixer R Delta-1010
Notice the S/PDIF In and Monitor Mixer names include "L" and "R" characters.
"L" indicates the left channel of the stereo stream, while "R" indicates right
channel.
ASIO DRIVER OUTPUT DEVICES: The Delta 1010's ASIO output devices
appear in stereo pairs. Because each device is stereo, you may see "left" and
"right" references within your software application. This allows the application
to pan audio left and right under software control. To send a signal to a Delta
ASIO output 1 (for example) as a mono output send, one would choose "Analog
1/2 Delta-1010" for that track's output port, and then pan that output hard left.
The ASIO outputs are named as follows:
Analog 1/2 Delta-1010
Analog 3/4 Delta-1010
Analog 5/6 Delta-1010
Analog 7/8 Delta-1010
S/PDIF L/R Delta-1010
MIDI DRIVERS: The Delta 1010 MIDI drivers, once enabled in your software's
MIDI Setup, will appear as a MIDI source and a MIDI port within that program's
track configuration windows. The MIDI input driver is named "MIDI In Delta-
16