M-Audio Delta 1010 Manual page 21

made to "WavOut." SM/ASIO are the software outputs on the Mac, while
WavOut are the software outputs on the PC.
The leftmost vertical column of Patchbay/Router page, "H/W Out 1/2," connects
this analog stereo pair to one of eight stereo sources:
1. The default setting, "WavOut 1/2", connects ports OUT1 and OUT2 to your
music software or Windows multimedia applet. In other words, when music
software plays audio to the device named "WavOut 1/2 Delta-1010" it will be
routed directly to the "hardware" analog outputs 1 & 2 of your 1010 rack-
mount chassis.
2. The second option, "Monitor Mixer", connects ports OUT1 and OUT2 to the
outputs of the Delta 1010 monitor mixer.
capabilities of the monitor mixer, please see the section "Monitor Mixer Page".
3. The third option, "S/PDIF In", connects ports OUT1 and OUT2 directly to the
hardware S/PDIF input on the Delta 1010 PCI host card. The left channel of
the S/PDIF In is routed to OUT1 and the right channel of the S/PDIF In is
routed to OUT2.
4. The fourth option, "S/PDIF In (L/R Rev.)", functions identically to the third
option, except that the left and right channels are swapped. Therefore in this
mode, the left channel of the S/PDIF In is routed to OUT2 and the right
channel of the S/PDIF In is routed to OUT1.
5. Selections five through eight connect the hardware analog inputs 1 & 2, 3 & 4,
5 & 6, or 7 & 8 (respectively) directly to the 1010's hardware analog outputs 1
& 2. For example, if "H/W In 1/2" were selected, any signal present at the IN1
port will be copied to OUT1, and any signal present at the IN2 port will be
copied to OUT2. This same behavior applies to "H/W In 3/4", "H/W In 5/6",
and "H/W In 7/8" when selected.
The next three vertical columns of the Patchbay/Router page (from left to right),
"H/W Out 3/4," "H/W Out 5/6," and "H/W Out 7/8," connect these hardware
analog outputs to one of seven sources. Since the three columns function
identically, we'll use "H/W Out 3/4" as the example:
1. The default setting, "WavOut 3/4", connects ports OUT3 and OUT4 to your
music software or Windows multimedia applet. In other words, when music
software plays audio to the device named "WavOut 3/4 Delta-1010" it will be
routed directly to the "hardware" analog outputs 3 & 4 of your 1010 rack-
mount chassis.
2. The second option, "S/PDIF In", connects ports OUT3 and OUT4 directly to
the hardware S/PDIF input on the Delta 1010 PCI host card. The left channel
of the S/PDIF In is routed to OUT3 and the right channel of the S/PDIF In is
routed to OUT4.
3. The third option, "S/PDIF In (L/R Rev.)", functions identically to the second
option, except that the left and right channels are swapped. Therefore in this
mode, the left channel of the S/PDIF In is routed to OUT4 and the right
channel of the S/PDIF In is routed to OUT3.
4. Options four through seven connect the hardware analog inputs 1 & 2, 3 & 4,
For more information of the
21