SATO CG2 Series Quick Manual page 24

Section 3: Loading Paper
CAUTION
• After printing, the print head and surrounding area are hot. Be careful not to get burned when replacing
paper immediately after printing.
• Touching the edge of the print head with bare hands could result in an injury.
• The cutter is sharp. Be careful not to cut your hands.
• Be careful not to get your fingers pinched while closing the top cover.
Adjusting the label dispensing stop position
Normally, the label is dispensed to the point where 0.1 inch (2 or 3 mm) of the label remains on the backing
paper. If the label is not dispensed at the regular position, use the Phillips tip of the potentiometer adjustment
screwdriver attached to the side of the paper holder to adjust the potentiometer for the label dispensing stop
position located at the bottom right of the front panel. After adjusting the stop position, dispense two or three
labels to fix the stop position.
Page 3-8
Potentiometer adjustment
screwdriver
CG2 Series Quick Guide