System Interconnections; Connecting The Dimension Digital Controller To The Projector - Runco LightStyle LS-12d Installation & Operation Manual

Installation
3.7
System
Interconnections
Connecting the Dimension
Digital Controller to the
Projector
Proceed as follows to connect the LS-12d system components to each other and to AC
power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• For best performance and to minimize cable clutter, use high-quality cables that are
only as long as necessary to connect two devices. (Don't use a 20-foot cable when a
6-foot cable will suffice.)
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Digital Video Connection: Connect the HDMI Out To Pri. Display connector on the
Dimension Digital Controller to the PRIMARY input on the projector. Similarly connect the
HDMI Out To Sec. Display connector on the Dimension Digital Controller to
SECONDARY input on the projector.
RS-232 Connection: Connect the Pri. Display Control output from the Dimension
Digital Controller to the RS232 input on the projector.
Use a standard, modular telephone cable with RJ11 plugs at both ends. On the projector
end, use the provided RJ11-to-DB9 adapter. This adapter is wired as shown in Figure
3-8.
RCV DATA
4
To/From
XMT DATA
3
Dimension
Digital
Controller
2
1, 5, 6
6-position
RJ-11 Male
6
1
Figure 3-8. RS-232 Connection from the Dimension Digital Controller to the
Projector
Runco recommends using the RS-232 communication link
Note
between the LS-12d projector and the Dimension Digital Controller.
However, display control using HDMI CEC control messages is
also possible. For more information on this capability, please
contact Runco Technical Support.
XMT DATA
RCV DATA
SIG GND
NO CONNECTION
36 LightStyle™ LS-12d Installation/Operation Manual
RS232
RS232
2
3
5
1, 4, 6,
7, 8, 9
DB-9 Male
1
6