Ethernet Network Connection To Dimension Digital Controller - Runco LightStyle LS-12d Installation & Operation Manual

Installation
Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the
Dimension Digital Controller; see Figure 3-14.
Control Control Sec. Display Control Sec. Display Control
HDMI 7 HDMI 7
HDMI 8 HDMI 8
Ethernet
to Ethernet
Hub, Router
or Gateway
Figure 3-14. Ethernet Network Connection to Dimension Digital Controller
RS-232 RS-232
IR IR
PC / Control PC / Control
HDMI Out HDMI Out
To Sec. Display To Sec. Display
HDMI Out HDMI Out
HDMI Out HDMI Out
Audio Only Audio Only To Pri. Display To Pri. Display
42 LightStyle™ LS-12d Installation/Operation Manual
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -