Pppoe (Point-To-Point Protocol Over Ethernet) - Rosewill RNX-N4 User Manual

Hide thumbs Also See for RNX-N4:
Table of Contents

Advertisement

Wireless Adapter
RNX-N4
• Primary / Secondary DNS Address: Specify the primary and secondary IP address,
which is assigned by your ISP.
• MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the
largest packet size (in bytes) that the router will send to the WAN. If LAN devices send
larger packets, the router will break them into smaller packets. Ideally, you should set
this to match the MTU of the connection to your ISP. Typical values are 1500 bytes for
an Ethernet connection and 1492 bytes for a PPPoE connection. If the router's MTU is
set too high, packets will be fragmented downstream. If the router's MTU is set too low,
the router will fragment packets unnecessarily and in extreme cases may be unable to
establish some connections. In either case, network performance can suffer.
• MAC Address: If you need to change the MAC address of the rounter's WAN-side
Ethernet interface, either type in an alternate MAC address (for example, the MAC
address of the router initially connected to the ISP) or click on Clone Your PCs MAC
Address.
• Click on the Save Settings button to store these settings.

6.2.4.3 PPPOE (POINT-TO-POINT PROTOCOL OVER ETHERNET)

• The WAN interface can be configured as PPPoE. This type of connection is usually
used for a DSL service and requires a username and password to connect.
• Select the PPPoE from the My Internet Connection drop-down list.
• Address Mode: PPPoE can be used with a dynamic or static IP address. If you select the
Dynamic IP radio button, then the IIP address in the next field is not required. However, if
you select the Static IP radio button, then the IP address in the next field is required.
• User Name: Specify the user name which is provided by your ISP.
• Password: Specify the password which is provided by your ISP, and then verify it once
again in the next field.
• Service Name: Specify the name of the ISP.
• Reconnect Mode: Select a reconnection time: Always on (A connection to the Internet is
45
User Manual

Advertisement

Table of Contents
loading

Table of Contents