Roland CD-2u Owner's Manual page 51

6
Press the [ ] (Record) button to enter recording-standby mode.
fig.rec-intmic04-e.eps
7
Press the [
Start your performance.
fig.rec-intmic05-e.eps
8
Press the [ ] (Stop) button to stop recording.
fig.rec-intmic06-e.eps
The recorded song will be added to the end of the SD memory card or CD-R/RW disc.
If you want to listen to the song you recorded, press the [
immediately after you stop recording.
Important
Sound will not be produced from the speakers while in recording-standby mode or while
●
recording. If you want to listen to the sound that's being recorded, you'll need to use
headphones. (Refer to Step 4 on Page 41.)
● When turning the [LINE] knob, you may hear a faint noise when the input level changes,
but this is not a malfunction.
● When connection cables with resistors are used, the volume level of equipment connected
to the inputs (EXT MIC (L, R), LINE IN) may be low. If this happens, use connection cables
that do not contain resistors.
● If you want to record your performance on
an electronic piano together with your voice,
make connections as shown in this
illustration so that the sound from the mic
will also be output from the speakers of the
electronic piano.
With this setup, set OUTPUT Select to "MIC"
to prevent a feedback loop from occurring
between the CD-2u/SD-2u and the
electronic piano. For details, refer to
"Selecting the Audio Source that's Sent from
the LINE OUT Jack" (Page 124).
Important
If you've finished recording a CD-R/RW disc and would like to play that disc on another CD
player, you'll need to execute the "Finalize" operation. You can finalize the CD-R/RW disc
when ejecting it. For details, refer to "Making a CD-R/RW Disc for Playback on Another CD
Player (Finalize)" (Page 99).
Blinking
] (Play) button to begin recording.
Lit
Recording an Electronic Instrument
Remote control
Remote control
Remote control
] (Play) button
Electronic
piano
INPUT
EXT MIC (L, R)
OUTPUT
LINE IN (L, R)
LINE OUT (L, R)
(continued)
Mics
CD-2u / SD-2u
51