Using Batteries - Roland CD-2u Owner's Manual

Turning the Power On and Off

Using Batteries

* If operating this unit on batteries, please use alkaline batteries or rechargeable Ni-MH batteries.
* If operating this unit on batteries, please disconnect the AC adaptor from this unit.
* Even if batteries are installed, the unit will turn off if you connect or disconnect the power cord
1
2
* When turning the unit upside down, take precautions to ensure that the buttons and knobs are
3
4
5
6
24
(continued)
Note
If you're operating the CD-2u/SD-2u on batteries, you won't be able to perform CD-
related operations such as recording, playing, or writing songs, etc.
from the AC outlet while the unit is turned on, or if you connect or disconnect the AC adaptor
from the unit. When this occurs, unsaved data may be lost. You must turn off the power before
you connect or disconnect the power cord or AC adaptor.
Turn the power off.
Disconnect all cables from the CD-2u/SD-2u.
Turn the CD-2u/SD-2u upside down and remove the battery cover.
protected from damage. Also, be sure to handle the unit with care so as to avoid dropping it, or
allowing it to fall or tip over.
fig.battery01-e.esp
Battery cover
Press here and pull upward.
Install six alkaline batteries (AA, LR6) or rechargeable Ni-MH batteries
(AA, HR6).
fig.battery02-e.esp
Close the battery cover and turn the CD-2u/SD-2u right side up.
Press and hold the [POWER] switch.
Release the switch when the screen appears in the display.
fig.power-on-battery.eps
Set the "Battery Type" (Page 36) parameter in the menu to specify the
type of batteries you're using.
* Make sure that the " " and "
are oriented correctly.
"