7
Press the [
] (Record) button to enter recording-standby mode.
fig.rec-intmic04-e.eps
8
Press the [
Start your performance.
fig.rec-intmic05-e.eps
9
Press the [
] (Stop) button to stop recording.
fig.rec-intmic06-e.eps
The recorded song will be added to the end of the SD memory card or CD-R/RW disc.
If you want to listen to the song you recorded, press the [
immediately after you stop recording.
Important
Depending on where the CD-2u/SD-2u is positioned in relation to the sound source, the
●
recorded sound may not be evenly distributed between the left and right speakers. In such
cases, you can adjust the left/right volume balance of the internal mics and record your
performance again. For details, refer to "Adjusting the Left/Right Volume Balance of the
Internal Mics" (Page 120).
●
When turning the [MIC] knob, you may hear a faint noise when the input level changes,
but this is not a malfunction.
Important
●
Since the CD-2u is equipped with highly-sensitive mics, undesired sounds such as the
operating noise of the CD-R/RW drive or the sound of buttons being pressed may be
recorded inadvertently. If you notice such problems, you can try lowering the input level
of the internal mics.
If you're recording to an SD memory card, no CD-R/RW drive operating noise will be
recorded.
●
If you've finished recording a CD-R/RW disc and would like to play that disc on another
CD player, you'll need to execute the "Finalize" operation. You can finalize the CD-R/RW
disc when ejecting it. For details, refer to "Making a CD-R/RW Disc for Playback on
Another CD Player (Finalize)" (Page 99).
Recording Acoustic Instruments or Vocals
Blinking
] (Play) button to begin recording.
Lit
Remote control
Remote control
Remote control
] (Play) button
(continued)
43