Table of Contents
Advertisement
FS-8700-102 Honeywell Zellweger IR-148-8_8-Channel Manual
5.2
CLIENT SIDE NODE DESCRIPTORS
Section Title
Nodes
Column Title
Function
Node_Name
Provide name for Node
Irrelevant for this driver when only one Node is connected.
Otherwise the Node-ID should be the number of
Node_ID
points/sensors for which the Zellweger unit is configured. A
unique Node_ID is recommended for each Zellweger Unit as it
may be useful in exposing Node status information
Protocol
Specify protocol used
Specify at which port the device is connected to the FieldServer
Port
Ports P1-P8 require a 232/485 converter.
Example
// Client Side Nodes
Nodes
Node_Name,
Node_ID,
DEV1,
1,
5.3
CLIENT SIDE MAP DESCRIPTORS
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title
Map_Descriptor_Name
Data_Array_Name
Data_Array_Offset
Function
5.3.2 Driver Related Map Descriptor Parameters
Column Title
Function
Node_Name
Name of Node to fetch data from
Length
Length of Map Descriptor
Expand Storage per point. Refer to
Extended_Storage*
Appendix A.1
2
Ports P1-P8 require a 232/485 converter.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Protocol,
Port
InfraTox,
R1
Function
Name of this Map Descriptor
Name of Data Array where data is to be
stored in the FieldServer
Starting location in Data Array
Function of Client Map Descriptor.
Legal Values
Up to 32 alphanumeric
characters
0-255
InfraTox, Infra-Tox.
P1-P8
Legal Values
Up to 32 alphanumeric characters
One of the Data Array names from "Data
Array" section above
0 to maximum specified in "Data Array"
section above
Passive_Client
Legal Values
One of the Node names specified in "Client Node
Descriptor" above
0 to Data_Array_Length (See Section 4).
Yes , No
2
, R1-R2
Advertisement
Table of Contents
