Table of Contents
Advertisement
FS-8700-133 Genisys Manual
5.3
Client S ide Map Descriptors
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title
Map_Descriptor_Name
Data_Array_Name
Data_Array_Offset
Function
5.3.2 Driver Related Map Descriptor Parameters
Column Title
Node_Name
Data_Type*
Address*
Length*
Genisys_OnValue_Change*
5.3.3 Timing Parameters
Column Title
Scan_Interval
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Function
Name of this Map Descriptor
Name of Data Array where data is to be
stored in the FieldServer
Starting location in Data Array
Function of Client Map Descriptor
Function
Name of Node to fetch data from
'Bit' each byte of Indication statuses will be stored in 8
consecutive locations in the Data Array. Similarly while
writing; Control byte will be composed from 8
consecutive locations of the Dara Array.
'Byte' each byte of Indication statuses will be stored as
an 8-Bit Integer at the specified location. Similarly while
writing; Control byte will be composed from a single
location of the Data Array.
Refer to Appendix A.1
Internally used parameter, if used specify value 0
Length of Map Descriptor
Number of indications to store or number of controls to
write as per Data_Type.
If this parameter is set to Yes, the driver will only send
controls if there is a value change when the Data Array
is updated.
Function
Rate at which data is polled
Page 8 of 13
Legal Values
Up to 32 alphanumeric characters
One of the Data Array names from "Data
Array" section above
0 to maximum specified in "Data Array"
section above
COS_Poller, COS_Read , Wrbx
Legal Values
One of the Node names
specified in "Client Node
Descriptor" above
Bit, Byte
0
Bit: 1-256, 8
Byte: 1-32, 1
Yes, -
Legal Values
≥0.001s
Advertisement
Table of Contents
