Table of Contents
Advertisement
FS-8700-132 Gamewell FCI-E3 Driver Manual
5.2
Client Side Node Parameters
Section Title
Nodes
Column Title
Node_Name
Node_ID
Protocol
FCI_Reset_Action_Option*
Connection
Example
// Client Side Nodes
Nodes
Node_Name
, Protocol
Panel-01
, FCI_E3
5.3
Client Side Map Descriptor Parameters
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title
Map_Descriptor_Name
Data_Array_Name
Data_Array_Offset
Function
2
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available
on specific hardware.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Function
Provide name for Node
Only required for networked configurations. Set the
Node_ID of the local panel to zero, and create one
Node Descriptor for each panel setting the Node_ID
to the panel number.
Specify protocol used
Only required for networked configurations:
When not specified or set to 'Reset_by_any_Node '
then the driver will reset the data array points
associated with the given node irrespective of the
reset message's origin.
When set to 'Reset_by_this_Node_Only' then the
driver only resets the data associated with the given
node if the reset originated from the same node.
Specify which port the device is connected to the
FieldServer
, Connection
, P1
Function
Name of this Map Descriptor
Name of Data Array where data is to be
stored in the FieldServer
Starting location in Data Array
Function of Client Map Descriptor.
Page 7 of 20
Legal Values
Up to 32 alphanumeric
characters
Whole numbers 0,1,2,3 ...
FCI_E3
Reset_by_any_Node,
Reset_by_this_Node_Only
2
P1-P8
Legal Values
Up to 32 alphanumeric characters
One of the Data Array names from "Data
Array" section above
0 to maximum specified in "Data Array"
section above
Passive_Client
Advertisement
Table of Contents
