Table of Contents
Advertisement
FS-8700-39 EST3 Driver Manual
Appendix A.1.7. DA_Bit_Name
6
The "Acknowledge
" state of a point is stored under this Data Array if configured.
0 – Acknowledged or Acknowledge not required.
1 – Point is not Acknowledged yet. To Acknowledge the point change the value to "0".
6
The EST3 panel is only able to send/accept Acknowledgement when the panel is in Proprietary Mode. Contact EST (Edwards Systems
Technology) for information on configuring the panel.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Page 15 of 25
Advertisement
Table of Contents
