Power Supply; Setting The Correct Time; Wake To Buzzer Alarm - Roadstar CLR-2630 Instruction Manual

POWER SUPPLY

This unit operates from a main supply of 230V ~ 50Hz. Connect the AC
power cord to the AC household main outlet. Ensure that the voltage
is as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 2 x UM4 battery, not included, into the battery compartment
located on the bottom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the radio
will not play. However, the battery back-up circuit will continue to
maintain the clock and alarm settings. When power is restored the clock
will display the correct time and alarm settings, and no adjustment is
necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be
lost. When power is restored the clock will begin to flash
indicating that the time and alarm settings must be corrected.
3 4
English

SETTING THE CORRECT TIME

1. In the normal Display mode, to set the TIME, keep pressed SET
2. To set the MONTH, press SET once more and the MONTH
3. To set the DAY, press SCAN+ or SCAN- again again and the
4. To set the TIME, press SET again one more time and the TIME
SETTING THE WAKE UP TIME
1. Set the correct time first.
2. Set the alarm time by following this procedure:
3. Press VOL/AL 1 Button or VOL/AL 2 two times.
4. Press the SCAN+ Button to advance hour.
5. Press VOL/AL 1 Button then SCAN+ to advance minutes.
6. To check the correct alarm time is set, press the VOL/AL1.

WAKE TO BUZZER ALARM

1. Set the alarm time as shown above.
English
Button for 3 seconds and the YEAR digits will flash. Press
SCAN+ or SCAN- to adjust the YEAR digits.
digits will flash. Press SCAN+ or SCAN- to adjust the MONTH
digits.
DAY digits will flash. Press SCAN+ or SCAN- adjust the DAY
digit.
TIME digit will flash. Press SCAN+ or SCAN- to adjust the
TIME digit.