Honda Marine BF200A Owner's Manual page 63

USE A SUITABLE TOOL
OIL FILTER
OIL DRAIN GUIDE
RUBBER SEAL
SERVICING YOUR OUTBOARD MOTOR
4. Clean the oil filter mounting base,
and coat the gasket of the new oil
filter with clean engine oil.
Use only a genuine Honda oil
f ilter or a f ilter of equivalent
quality specif ied f or your model.
Using the wrong f ilter, or a non-
Honda f ilter which is not of
equivalent quality, may cause
engine damage.
5. Screw on the new filter by hand
until it contacts the engine, then
use a suitable tool to tighten the
filter an additional 7/8 turn.
OIL FILTER TIGHTENING
TORQUE:
16 lbf·ft (22 N·m , 2.2 kgf·m)
6. Return the outboard motor to the
vertical position, and fill the
crankcase with the specified
amount (p. 60 ) of the
recommended oil.
7. Start the engine and check for
leaks.
Running the engine without water
can cause serious engine damage.
If you are changing the oil f ilter
while the outboard motor is out of
the water, use the water hose f lush
port and a hose to supply water.
8. Stop the engine, and check the oil
level as described on page
necessary, add oil to bring the oil
level to the upper limit mark on the
dipstick.
59 . If
61