Qlogic SANbox 5800V Series User Manual page 62

4 – Managing Switches
Using the Switch Data Window
Temperature
Fan 1 Status
Fan 2 Status
Power Supply 1 Status
Power Supply 2 Status
Temperature Failure Port
Shutdown
Warning Temperature
Failure Temperature
POST Status
POST Fault Code
Test Status
Test Fault Code
IPv4 Enabled
IPv4 Address
IPv4 Subnet Mask
IPv6 Gateway
IPv6 Enabled
IPv6 Address
IPv6 Gateway
CPU0 MAC Address
CPU1 MAC Address
SNMP Enabled
SNMP v3 Security Enabled
4-4
Table 4-1. Switch Data Window Entries (Continued)
Entry
Network Group
Description
Internal switch temperature °C
Fan 1 status
Fan 2 status
Power supply 1 status
Power supply 2 status
Non-configurable (always enabled for this switch). All
ports are downed when the switch temperature
exceeds the Failure Temperature.
Non-configurable temperature threshold (65° Celsius)
above which a warning condition alarm is generated.
Non-configurable temperature threshold (70° Celsius)
above which a failure condition alarm is generated.
Status from the most recent Power On Self Test
Fault code from the most recent Power On Self Test
The current diagnostic test status of switch.
The code value for the last recorded diagnostic test
status recorded on the switch.
Internet Protocol version 4 Enabled status
Mask that determines the IP address subnet
Mask that determines the IP address subnet
Gateway address
Internet Protocol version 6 Enabled status
Mask that determines the IP address subnet
Gateway address
NA-does not apply to this switch
NA-does not apply to this switch
SNMP enabled or disabled
SNMP v3 Security enabled or disabled
S
59264-02 A