Qlogic SANbox 5800V Series User Manual page 120

5 – Managing Ports
Port Statistics Data Window
Decode Errors
Ep Connects
FBusy
Flow Errors
FReject
Invalid CRC
Invalid Destination
Address
Link Failures
LIP (AL_PD,AL_PS)
LIP(f7,AL_PS)
LIP(f7,f7)
LIP(f8,AL_PS)
LIP(f8,f7)
Login
Logout
5-8
Table 5-2. Port Statistics Data Window Entries (Continued)
Entry
Number of invalid transmission words detected during decod-
ing. Decoding is from the 10-bit characters and special K char-
acters.
Number of E_Port logins.
Number of class 2 and class 3 fabric busy (F_BSY) frames
generated by this port in response to incoming frames. This
usually indicates a busy condition on the fabric or N_port that
is preventing delivery of this frame.
Number of times a frame is received and all the switch ports
receive buffers are full. The normal Fabric Login exchange of
flow control credit should prevent this from occurring. The
frame will be discarded.
Number of frames, from devices, that have been rejected.
Frames can be rejected for any of a large number of reasons.
Number of invalid Cyclic Redundancy Check (CRC) frames
detected.
Number of address identifier (S_ID, D_ID) errors. AL_PA
equals non-zero AL_PA found on F_Port.
Number of optical link failures detected by this port. A link fail-
ure is a loss of synchronization or by loss of signal while not in
the offline state. A loss of signal causes the switch to attempt
to re-establish the link. If the link is not re-established, a link
failure is counted. A link reset is performed after a link failure.
Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,
performed.
This LIP is used to reinitialize the loop. An L_port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.
A loop initialization primitive frame used to acquire an AL_PA.
This LIP denotes a loop failure detected by the L_port identi-
fied by AL_PS.
A loop initialization primitive frame used to indicate that a Loop
Failure has been detected at its receiver and does not have a
valid AL_PA.
Number of device logins that have occurred on the switch.
Number of device logouts that have occurred on the switch.
Description
S
59264-02 A