Installation/Step A - Zenith VR2135 Operating Manual And Warranty

INSTALLATION/Step A
VCR Front Audio Video (In) Connections
VCR
Front Panel
.... POWER _ISTOp&EJECT -" . _,-
_-R
®®®
l_plcel
Accessory
Jack Panel
J
,7: /_
Accessory
Components:
• Another VCR
._.Camcorder
-Video Camera
Satellite Receiver
Laser Disk Player
Stereo Hi-Fi
Use the VCR front L-AUDIO-R/VIDEO (In)jacks for easy connection when using an accessory compo-
nent temporarily. The accessory component, connected to the VCR FRONT L-AUDIO-R/VIDEO (In)
jacks, will override the component connected to the VCR REAR L-AUDIO-R/VIDEO IN jacks.
VCR CH3-4 Switch (Works with TV Ant In Connections Only)
to
h. 3
VCR CH3-4 Switch - This switch sends the signal
produced by the VCR to the TV set over Channel
3. ALL SYSTEM OPERATIONS (VCR Tun-
hag, Playback, Recording, Timer Recording
etc.) WILL HAVE TO BE PERFORMED
WITH THE TV TUNED TO CHANNEL 3. (Be-
fore the TV can receive an image sent from the
VCR, while the VCR is On, the TV must be On
and tuned to Channel 3. TV/VCR Switch set to
VCR, so VCR appears in Message Center.)
VCR
loclt IJw_l
If Channel 3 does not work, set the Ch3-4 switch
to Ch- 4. ALL SYSTEM OPERATIONS (VCR
Tuning, Playback, Recording, Timer Recording
etc.) WILL THEN HAVE TO BE PER-
FORMED WITH THE TV TUNED TO CHAN-
NEL 4. (Before the TV can receive an image sent
from the VCR, while the VCR is On, the TV must
be On and tuned to Channel 4. TV/VCR Switch set
to VCR, so VCR appears in Message Center.)
1--4