Vcr Plus - Zenith VR2135 Operating Manual And Warranty

VCR PLUS SETUP
Preliminary Setup, Cable Service with a Cable Box
Cable Box
Tunes_to
.... Channel 19 .... --- ... - - -
i
I Cable Box
IR (Infra Red)
-- Signal Path
from VCR
to Cable Box
J
J
Wall,Wlndow
or any .....
Reflective
Surface to
,": Bounce IR
Signals to
Cable Box
-- Clock must be set to correct time.
-- Source Select must be set to Tuner.
Tuning Band must be set to CATV.
-- VCR, cable box and TV must be turned On.
-- TV/VCR set to VCR (VCR appears in Message
Center.)
-- TV on and tuned to Channel 3, or TV
Audio/Video In as the source of the TV picture,
as appropriate.
VCR tuned to cable box output channel number:
2, 3, 4, 5 or 6.
-- Cable box must be connected to VCR ANT IN
tin FROM ANT).
-- IR 0mfra Red) Signal path
from
the VCR to the
cable box must be unobstructed.
1. For the Cable Box Test
Get the following information and enter in appropri-
ate spaces below.
Cable Box Output Channel Number.
May be printed in cable box owner's manual or on
cable box. If not, call cable company for number;
2, 3, 4, 5 or 6.
"MFR" Number.
A series of numbers for your particular cable box.
If the fLrst number does not work, try all the others
in sequence. See page 12-3.
2. Complete VCR Plus Channel Mapping Work-
sheet.
See page 12-4
Press CH MAP to begin VCR Plus Setup,
follow on-screen instructions.
Write In:
Cable Box Output Channel Number
If cable box test is successful, the cable box will
tune to Channel 19 as shown above.
"MFR" Number(s)
12 --2