Zenith VR2135 Operating Manual And Warranty page 36

SERVICE INFORMATION
Timer recording is not possible.
Clock is not set to correct time. Set clock to correct time.
i
!Timer has been programmed Reprogram Timer.
iincorrectly.
VCR is on. I'urn VCR off to activate Timer.
Reprogram Timer.
J
TillER SET or TMR does not appear
after programming timer.
' Tuning Problems
Some channels are skipped over when Those channels are preset to be skipped. Restore cha'tmels to channel search
scanning channels, sequence; select ADD next to channel
:. number.
Channel cannot be switched. VCR is in Timer Recording mode.
Picture and sound are weak or missing, gntenna or cables are loose.
Press POWER to release VCR from
Timer Recording mode.
Tighten connections
or replace
cable.
Stereo is not present from VCR output.
Audio-Stereo Record/Playback Problems
TV is not Stereo. VCR not connected to Connect VCR to TV Audio/Video In (or
TV Audio/Video Input jacks. Hi-Fi Stereo Audio In jacks.)
VCR Record Mode was not set to Stereo.
Tape recorded with 2rid Audio or
Vlonaural specified as Record Mode.
VCR Audio/Video Output jacks not
connected to TV Audio/Video input
acks.
Set VCR Audio to appropriate mode.
I
Connect VCR Audio/Video Out to "I"V
Audio/Video In.
VCR records program on different chan-
nel than channel specified.
VCR Plus Problems
Channel Map Procedure is incorrect or
was not performed.
Cable Box not tuned to channel you
wanted to record.
Recorded wrong channel or no channel
with Cable Box.
No program on cable system.
Cable Box not turned on.
VCR not tuned to Cable Box Output
Channel; 2, 3, 4, 5, 6, 7, 8 or 9.
Cable system not operating.
i
Channel Map for your local broadcast
area.
Tune Cable Box to channel you wish to
record.
Turn
Cable Box oh and leave on.
Tune VCR to Cable Box Output Channel
number. Call cable company for number
if necessary.
Call cable company for information.
14 _2