Air Conditioneruse; Starting Your Air Conditioner - Digital Control - Whirlpool YACQ088XP0 Use & Care Manual

AIR CONDITIONERUSE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Timer
Turb°O 0(_)
Fan _ HighO
Speed k_
Lo01 FanOnly Power
Saver
1. Remove clear protective film from control panel and front
panel badge.
2. Press POWER to turn on air conditioner.
G
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C). When it is turned on at
all other times, it will display the previous settings.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1. Press MODE until you see the indicator light come on for the
setting you desire.
2=
Choose AUTO, COOL, FAN ONLY or POWER SAVER.
• Auto - Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
• Cool - Cools room. You can select fan speed by pressing
Fan Speed. You can then adjust temperature by pressing
the plus or minus button.
• Fan Only - Only the fan runs. Display shows "FO"
(fan only).
NOTE: Fan runs on Turbo speed only.
• Power Saver - Fan runs only when cooling is needed. Fan
stops running when the room temperature matches the
temperature you set.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
circulated as often. Use Power Saver when you are
asleep or away from home.
0 0 0 0
MODE Auto Cool FanOnly Power
Saver
Fan Speed
NOTE: The Fan Speed button will operate only when Cool or
Power Saver mode has been selected.
1. Press FAN SPEED until you see the indicator light come on
for the setting you desire.
2. Choose TURBO, HIGH or LOW.
Turbo O
s;ae_d @ HighO
Low
0
Temperature
• Press the plus button to raise the temperature 1° until it
reaches 86°F (30°C).
TIME
• Press the minus button to lower the temperature 1° until it
reaches 64°F (18°C).
To change the temperature display from °F to °C:
1. Turn off the air conditioner.
2. While the air conditioner is off, press and hold down the
MODE and FAN SPEED buttons while pressing POWER to
turn the air conditioner on,
NOTE: Follow these same steps to change the temperature
display from °C to °E