Rack Slide Kit (M00-280-610); Precision Y5020A Current Shunt - Fluke 5220A Instruction Manual

6-4.

Rack Slide Kit (M00-280-610)

The 5220A can be rack mounted in a 24-inch deep equipment rack using the Rack Slide
Kit, model M00-280-610. Use the following procedure to install the kit:
1. Remove the horizontal side trim decal from both sides of the instrument.
2. Refer to Figure 6-2. Using the screws supplied with the kit, attach the chassis section
(B) of the slide kit to each side of the unit. Use the center row of mounting holes.
3. Install the cabinet section (D) of the center section (C) in the equipment rack.
4. Pull the center section of the slide out through the front of the equipment rack until it
locks in the extended position.
5. Depress the spring locks on the chassis section (B) and join sections B and C.
6. Push the instrument into the equipment rack and then pull it out to the extended
position. The spring locks should limit the rack slide travel.
6-5.

Precision Y5020A Current Shunt

The Model Y5020A is a precision, high-current shunt recommended for use in calibrating
the Model 5220A Transconductance Amplifier. An instruction manual is suppled with the
unit.
Option and Accessory Information
6
Accessories
6-3