Table of Contents
Advertisement
Service Information
Each 5725A Amplifier is warranted to the original
purchaser for a period of one year beginning on the date
received. The warranty is located at the front of this
manual.
Factory-authorized service and technical advice for the
5725A is available at Fluke Service Centers. A complete
list of service centers is available at www.fluke.com.
Warning
Servicing described in this manual is to be
done by qualified service personnel only. To
avoid electrical shock, do not service the
5725A unless you are qualified to do so.
The owner may choose to repair a 5725A using the
troubleshooting information in Chapter 7 of the Instruction
Manual to isolate a faulty module, then use the Module
Exchange Program. Refer to the Fluke catalog or contact
a Service Center representative for the module exchange
procedure.
Placement and Rack Mounting
You can stack the 5725A on top of or below the 5700A
Calibrator. (Choose the configuration that provides the
easiest access to the 5700A Calibrator controls.) Or, you
can mount the 5725A in a standard-width, 24-inch (61-
cm) deep equipment rack. For bench-top stacking, the
5725A is equipped with non-skid feet. To mount the
5725A in an equipment rack, order the accessory 5725A
Rack Mount Kit, Model Y5735. An instruction sheet is
packed with the kit.
Use only the rack mount slides included in
the Y5735 kit. Rack mount slides intended for
other instruments can block the side
ventilation holes on the 5725A and cause
overheating.
Getting Started
Service Information
Caution
11
Advertisement
Table of Contents
