Using The Optional Trim Stop; Using The Optional Hand Rail Fence - Festool Domino XL DF 700 Supplemental User's Manual

Using the Optional Trim Stop

The optional Trim Stop is used to securely hold small work-
pieces for cutting mortises.
Installing the Trim Stop
1. With the fence tilted to 90 degrees, slide the Trim Stop
over the fence face of the Domino joiner as shown. Make
sure the Trim Stop is fully seated onto the joiner's fence.
2. Slide the two latch tabs inward.
3. Tighten the two thumbscrews.
Setting the Stop Width
1. Loosen the two green thumbscrews on the bottom of the
Trim Stop.
2. Place the workpiece between the two guides and slide the
guides inward.
3. Use the position gauge on the Domino joiner fence face
to center the workpiece.
4. With the side guides tight to the workpiece and the
workpiece centered in the position gauge, tighten the two
thumbscrews.
Hint: Make note of where the workpiece lines up
on the sight gauge, and use the sight gauge when
cutting the mortise on the mating frame for a T-joint
frame.

Using the Optional Hand Rail Fence

The optional hand rail fence is used to help stabilize rounded
workpieces that won't otherwise rest flat against the fence.
Installing the Hand Rail Fence
1. With the fence tilted to 90 degrees, slide the hand rail
fence over the fence face of the Domino joiner as shown.
Make sure the hand rail fence is fully seated onto the
joiner's fence.
2. Slide the two latch tabs inward.
3. Tighten the two thumbscrews.
Locked
Position
Supplemental Owner's Manual
Thumbscrew
Latch
Locked
Position
Sight
Gauge
If the hand rail fence is not sitting perfectly centered on the
mortising location, it can be shifted to the side by adjusting
the four gib screws.
Thumbscrew
Latch
Thumbscrews
Workpiece
Round
Stock
Gib Screws (4)
13