Page 5
- The DF 500 Q must only be fi tted with the Fault correction jointer bits offered by Festool for this purpose. The use of other jointer bits is prohibited due The specifi ed illustrations can be found at the to the increased risk of injury.
Page 6
- Release the spindle lock. Always connect the machine to a dust - Slide the guide frame onto the motor unit until extractor. You can connect a Festool ex- it audibly engages. tractor with an extractor hose diameter of 27 mm to the extractor connector Adjusting the milling depth (2.2).
Page 7
The accessory and tool order number can be jointing bit in the Domino dowel jointer (Chap. 8.1). found in the Festool catalogue or on the Internet - Set the jointing depth (Chap. 8.2). The join- under “www.festool.com”. ting depth must be at least 3 mm smaller than the workpiece thickness so that the dowelled joint is supportable.
Page 8
Example applications (The following images A1 to A6.3 are on a separate enclosed sheet). A1.1 - A1.4 Stable and non-twisting mitred frame joint. Very stable block frame joint. Very stable and non-twisting wood joints in frame and chair construction. A4.1 - A4.3 Stable, non-twisting and precisely fi tting board joint (mitred). A5.1 Stable and precisely fi...
Page 9
Directeur de recherce et développement ja normatiivisten ohjeiden mukainen: EN 60 745, EN 55 014, EN 61 000 direktiivien 98/37/EY, 89/336/EY määräysten mukaan. Festool GmbH Wertstr. 20 D-73240 Wendlingen EF-konformitetserklæring: Vi erklærer at have alene Dr. Johannes Steimel ansvaret for, at dette produkt er i overensstem- melse med de følgende normer eller normative...
Need help?
Do you have a question about the DOMINO DF 500 Q and is the answer not in the manual?
Questions and answers