Range - Whirlpool SF385PEG Use & Care Manual

SEALED SURFACE BURNERS AND COOKTOP (com.)
Toclean theburners:
1.
Pull the burner cap straight up from the
burner base.
2. Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
mildly abrasive scrubbing pad or cleanser.
Do not clean the burner cap in a dishwasher or
self-cleaning oven.
3. If the gas tube opening has become soiled or
clogged, use a cotton swab or a soft cloth to
clean the area.
4.
If the ports are clogged, clean them with a
straight pin. Do not
enlarge or distort the
port. Do not use a
wooden toothpick. If
the burner needs to be
I
adjusted, call a qualified
technician for service.
5. After cleaning the gas tube opening and ports,
Alignment replace the burner cap.
To replace the burner
cap, make sure the
alignment pins on
the burner cap are
properly aligned with
the burner base.
6. Turn on the burner to see if it will light. If the
burner does not light after you have cleaned it,
contact a designated service technician. Do
not service the sealed burner yourself.
REMOVING THE OVEN D OOR
For normal use of your range, you do not need to
remove the door. However, if you find it necessary
to remove the door, follow the instructions in this
section.
NOTE: The oven door is heavy.
Before removing the door:
1.
Use a putty knife or screwdriver and insert it at
the bottom corner of the door stop clip.
2, Pry door stop clip free and remove from front
frame hinge slot, Take care not to scratch
porcelain.
3. Repeat procedure for other door stop clip,
Door removal Door stop clip
pin h°l_ I ! ° Range
Hinge
hanger hinge slot
26