Whirlpool SF387LEGQ5 Use & Care Manual page 26

ii!jiii_ ]!tiii_ iiill!_1_: Jiii_ii!! _i i ll i i_i_i !i!!_iiii!il _ii_! !ii_ i ii)l _ii_!!]i !_',' I_i:_i:_ i_!: )
1.
il;ii_,_lili!i_:il_i i)iii_i_!_ [ii!_ii[f_'[:_!_:
Pull the burner cap straight up from the
burner base.
2. Clean the burner cap with warm, soapy water
and a sponge. You can also clean it with a
non-abrasive scrubbing pad or mild abrasive
powdered cleanser.
Do not clean the burner cap in a dishwasher.
3. If the gas tube opening has become soiled or
clogged, use a damp cloth to clean the area.
4,
If the ports are clogged, clean them with a
straight pin. Do not
enlarge or distort the
port. Do not use a
wooden toothpick.
If the burner needs to
be adjusted, call a
qualified technician
for service.
5. After cleaning the gas tube opening and ports,
replace the burner
O cap. To replace the
@
Gas tube opening
burner cap, make
sure the alignment
pins on the cap are
properly aligned with
the burner base.
6.
Turn on the burner to see if it will light. If the
burner does not light after you have cleaned it,
recheck cap alignment or contact a designated
service technician. Do not service the sealed
burner yourself.
For normal use of your range, you do not need to
remove the door. However, if you find it necessary
to remove the door, follow the instructions in this
section.
NOTE: The oven door is heavy.
Before removing the door:
1. Use a putty knife or screwdriver and insert it at
the bottom corner of the door stop clip.
2. Pry door stop clip free and remove from front
frame hinge slot. Take care not to scratch
porcelain.
3. Repeat procedure for other door stop clip.
Door removal Door stop clip
i
pin hole
Hinge Front frame
hanger hinge slot
26