Hardware Installation
Wall Mount Hardware
The following hardware is required to complete the wall mount of an Altitude 4600
Series Access Point:
Two wide-shoulder Phillips pan head self-tapping screws
●
Two wall anchors
●
Security cable (optional)
●
NOTE
In the event the original mounting screws are lost, the following screws can be used: (ANSI
Standard) #6-18 X 0.875in. Type A or AB Self-Tapping Screw, or (ANSI Standard Metric) M3.5 X
0.6 X 20mm Type D Self-Tapping Screw.
Wall Mount Procedure
14
Integrated Antenna Wall Mount
Altitude 4600 Series Access Point Installation Guide