Connecting - Uniden DCT646-2 Series Quick Easy Steps Manual

Liquid Damage
Moisture and liquid can damage your cordless phone. In case of accidental submersion, please read the following steps.
Case Action
Wipe off the [iquid, and use as normal
If the handset or base is exposed to
moisture or [iquid, but only affects the
exterior plastic housing.
If moisture or liquid has entered the
)[astic-housing (i.e. [iquid can be heard
in the phone or liquid has entered the
handset battery compartment or vent
openings on the base).
Handset:
i) Remove the battery cover and leave it off for ventilation.
2) Remove the battery pack by disconnecting.
3) Leave the battery cover off and the battery pack disconnected for at [east 3 days.
4) Once the handset is completely dry, reconnect the battery pack and the battery cover.
5) Recharge the handset's battery pack for 20 hours before using again.
Base:
i) Disconnect the AC adapter from the base unit, cutting off electrical power.
2) Disconnect the telephone cord from the base unit.
3) Let dry for at [east 3 days.
IMPORTANT: You must unplug the telephone line while recharging the battery pack to
avoid charge interruption.
CAUTION:
DO NOT use a microwave oven to speed up the drying process. This wit[ cause permanent
damage to the handset, base and the microwave oven.
After following these steps, if your cordless telephone does not work, please send to:
Uniden America Corporation
Parts and Service Division
4700 Amon Carter Blvd.
Ft. Worth TX 76155
1-800-554-3988. Monday through Friday
8 a.m. to 5 p.m. CST
www.uniden.com TROUBLESHOOTING [59]