Installation - Uniden DCT646-2 Series Quick Easy Steps Manual

[54]
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code.
To change the digital security code:
1. Perform the "System Reset" menu options ("De-register the Handset" and
"Replacing the Base Setting") for all the handsets you have (see page 27).
2. To register all the handsets do the following steps:
1) Place a handset, one at a time in the base.
2) Registration starts automatically.
White registering H_,_d_et Regi-te, i_°_gappears in the display.
3) When the registration is complete, _,_qi :_-_ in_-, r:,-_,_ iete appears in the display.
4) Repeat steps 1 - 3 for another handsets.
If the registration fails, Regi-t,ati,:,,_ F_i ied appears in the display. Try the steps
above again.
Installing the Beltclip
To attach the be[tc[ip
Insert the bettctip into the holes on each side of the handset.
Press down until it dicks.
To remove the beltclip
Putt either side of the bettctip to release the tabs from the holes.
Headset Installation
Your phone may be used with an optional headset, the Uniden
HS910. To use this feature, insert the headset plug into the
headset jack. Your phone is ready for hands-free conversations
(headset may be purchased by catting the Uniden Parts Department
or visiting the web site. See page 1).
ADDITIONAL INFORMATION www.uniden.com